How should I tie my pointe shoe ribbons?

After the ribbons are sewn on, tie the shoe to the foot before trimming the ends.

To tie the ribbons on, cross them over the top of the foot. Then bring them to the back of the ankle on either side. Cross them at the back and bring them back to the front.

Now, bring one ribbon to the inner side of the ankle and hold it there. Bring the other ribbon around the back of the ankle again, until it meets the first ribbon on the inner ankle.

Tie a double knot in the hollow area between the ankle bone and the Achilles tendon. Never tie ribbons on the Achilles tendon, at the back of the ankle, because this can damage the tendon. Finally, tuck the ends of the knotted ribbons under the wrapped ribbons, for a neat appearance.

If there is too much excess ribbon after you tie the knot, it may be difficult to tuck the ends in neatly. While the shoes are tied, you may trim the ends. Be careful not to trim too far, though, or the shoes may be hard to tie in future, especially if the ribbon shrinks slightly after being worn. Beginners should not trim at all until the teacher has approved how the ribbons have been sewn and tied. Trimming on a slant may help prevent unraveling of the cut edge.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

X